SeaSoft Drysuit Hood 3mm

SeaSoft Drysuit Hood 3mm Features

When diving, the deeper a diver goes the colder it generally gets and with increasing pressure, a typical neoprene hood gets thinner. If the temperature is getting colder and your hood is getting thinner, you're going to get cold. And, when you consider that 40% of heat loss is from the head area, it seems like this would be a place to make sure you are adequately protected to ensure warmth and comfort.

All of our SEASOFT Ti PRO Hoods have compressed neoprene for the back panels of the hood. This means that no matter how deep you go, they are still their original thickness and working to keep you warm!

You will not find any seams down the middle of the chin either. This seam, found in almost all hoods today, can cause jaw fatigue. The seam is there because it is less expensive to make a hood from just two halves. We do not believe that a hood is the place to go cheap.

Key Features

  • The 3 back panels are compressed neoprene, your hood should not be getting thinner as you go deeper!
  • There are no seams in the middle of the seam to cause jaw fatique.
  • Uses 4 different types of neoprene to make this hood, others use one or two.
  • There are two tiny holes in the top of the hood with a baffle system to allow air to purge.
  • High quality neoprene is used throughout on every hood.
  • There is "skin in" on the neck to bind to your drysuit seal.

Warranty Information

This product has a limited warranty of 24 months.

www.seasoftscuba.com
(800) 939-5510