Seasoft : Picture 1 regular
Seasoft

Top Rated Gear
Seasoft Pro/C6 6 mm Dry Suit Hood for Full Face Mask (FFM)

Your Price

$71.99
Buy more and save
Quantity Discount
QuantityAmount

The quantity discount will be reflected in your shopping cart

You save: $8.00 (10%)

List: $79.99

In Stock & Ready to Ship

More Product Options

Seasoft : Picture 1 regular

About Seasoft Pro/C6 6 mm Dry Suit Hood for Full Face Mask (FFM)

When Diving, the Deeper a diver goes the Colder it generally gets and with Increasing Pressure, a Typical Neoprene Hood gets thinner. If the Temperature is getting Colder and your Hood is getting thinner, you're going to get Cold. And, when you consider that 35% of Heat Loss is from the Head area, it seems like this would be a place to make sure you are Adequately-Protected to ensure Warmth and Comfort.

The SEASOFT Titanium PRO/C6 Hood has 4 different types of Nylon ll Neoprene including Compressed Neoprene for the Back-3 Panels of the Hood. This means that no matter how deep you go, they are still their Original-Thickness and working to keep you Warm! You will not find any Seams down the middle of the Chin either. This Seam, found in almost all Hoods today, can cause Jaw Fatigue. The Seam is there because it is less expensive to make a hood from just two halves. We do not believe that a hood is the place to go cheap.

The Hood has Titanium Flakes Poil Technology that creates 2-Layers of Titanium Foil that Reflects Cold away and Reflects your Heat in keeping you Warmer than Hoods without this Technology. The 6 mm material is going to Naturally-Fit and Stretch around your head better. This leaves less room for cold water to occupy UNDER your hood, this helps to maintain warmth as well. There are also two very Small-Holes for Air-to-Escape from the Inside-Crown of the Hood in case air enters your hood with a Thin-Baffle Built-Over the Holes to prevent Water from Entering.

The SEASOFT PRO / C6 6 mm Dry Suit Hood is a Commercial Dry Suit Hood designed to be worn with a Full Face Mask in Cold Water. The PRO/C6 has a Layer of Skin-In Neoprene on the Inside and on the Outside with a Layer of Tough Nylon in between these two layers. The Skin-In Neoprene allows the Hood to Seal to your Face and the Full Face Mask to Seal to the Hood. SeaSoft Pro/C6 Wetsuit Hood use 6 mm Neoprene with Glued and Sewn Seams for Strength and Durability. The Hood is available in sizes Medium, Large, X-Large and 2X-Large, is Black in Color and is covered by a 24 month limited warranty.

The Seasoft Pro/C6 6 mm Dry Suit Hood for Full Face Mask (FFM) is commonly used for Cold Water and more. The Seasoft Pro/C6 6 mm Dry Suit Hood for Full Face Mask (FFM) is popular because customers like the following qualities of the Seasoft Pro/C6 6 mm Dry Suit Hood for Full Face Mask (FFM): Good Fit, Warm.

Warranty Information

This product has a limited warranty of 24 months.

http://www.seasoftscuba.com
8009395510

Seasoft Pro/C6 6 mm Dry Suit Hood for Full Face Mask (FFM) Features

  • Specifically Designed for Full Face Mask Divers in Cold Water
  • 35% of Heat Loss is from the Head
  • Construction: 4 Different Types of Nylon ll Neoprene
  • Compressed Neoprene: Back 3-Panels of the Hood
  • Compressed Neoprene: Won't Get Thinner at Depth
  • Thicker Neoprene: Warmer Dive
  • No Chin Seam: Reduced Jaw Fatigue
  • Titanium Flakes Poil Technology: 2-Layers of Titanium Foil
  • Titanium Foil: Reflects Cold Away and Reflects your Heat In
  • 6 mm Naturally-Fit and Stretch Around Head Better
  • Small-Holes with Thin-Baffle on Inside-Crown Vent Trapped Air
  • Seams Glued and Sewn for Strength and Durability
  • Layer of Skin-In Neoprene on Inside and Outside with Layer of Tough Nylon in Between
  • Skin-In Neoprene allows Hood to Seal to Face and Full Face Mask to Seal to Hood
  • Sizes: Medium, Large, X-Large and 2X-Large
  • Color: Black
  • 2 Year Limited Warranty

Seasoft Pro/C6 6 mm Dry Suit Hood for Full Face Mask (FFM) Customer Reviews Powered by TurnTo®

Review Summary

 
4.5

(based on 8 reviews)

100%

of respondents would recommend this to a friend.

Ratings Distribution

  • 5 Stars

     

    (4)

  • 4 Stars

     

    (4)

  • 3 Stars

     

    (0)

  • 2 Stars

     

    (0)

  • 1 Stars

     

    (0)

Most Liked Positive Review

 

Really Works!

LP always delivers on time. You can't go wrong with Leisure Pro.

Reviewed by 8 customers

Displaying reviews 1-5

Back to top

Previous | Next »

 
4.0

Fine hood with some alteration . . .

By

from San Francisco, CA, US

I use a FFMs with both drysuits and wetsuits; so I bought two hoods and added a 3 mm bib to one of them. Altogether, a fine product; though it could have used a bit more reinforcement where the skin met the nylon -- something I had added . . .

 
4.0

Kept mask on and head dry

By

Dove wih this hood on yesterday working under a boat. Kept ffm secured and sealed great. Kept head dry. Used with dry suit did not have any problems. Did notice that the seams around the face on the hood could be better. Can see the seam coming apart in the future.

 
4.0

Good hood for FFM, but not as general dry suit hood

By

This is an excellent hood for drysuit and FFM use. The FFM seals right against the hood and there is no water intrusion. the hood feels like a perfect fit when I try it on at surface. However, the FFM strap helps hold the hood tight around your head. So if you use without a FFM, the hood stretches enough to get a big air pocket that affects your buoyancy and trim, significantly more than any other hood I've used (been drysuit diving for 25 years). For this reason, I only give it four stars. So, excellent and highly recommended when using a FFM, but not recommended if you don't use a FFM.

 
5.0

Really Works!

By

LP always delivers on time. You can't go wrong with Leisure Pro.

 
5.0

Perfect for FFM

By

I used this hood for my Padi FFM certification. After using several other hoods with the typical big head ballooning from excess air from the FFM. I found the seal on this hood to be excellent. It has a neoprene skin inside and out for a mask over the hood seal. Take the time to measure your head as it does require an almost perfect fit. I normally wear a large however i measured my head for this hood and ordered a medium. Initially it felt a little tight, but when in the water it worked out perfectly and it will stretch a bit. My friend ordered a large as he normally does and hat issues with the seal so measure and then order you won't be dissapointed I had no issues with a tight fit on the neck. .

Displaying reviews 1-5

Back to top

Previous | Next »

Q&A

Questions & Answers Powered by TurnTo®

Questions about this item:

Shopper  Why Did You Choose This?
Patrick W  I wanted a neoprene dry suit hood that would work with my Guardian FFM.
Chris T  Does this hood have a skirt that tucks into the neck of the wetsuit, or does it not have a skirt?
DAN P  It has a short neck flap, designed to work with a dry suit. The way they cut the jaw is very good. It takes the pressure off the jaw,, no single seam down the center, there are two allowing for a comfortable fit. I use the same mask as shown, hood works very well, does not leak, old hood would. Would and will buy again. Dan
ELIZABETH R  It does not have a skirt
geoffrey a  no skirt
PETER S  No Skirt to tuck
DAVID O  No skirt. As the description says, it is for a dry suit. There is adequate neoprene in the neck to cover a dry suit neck seal, but that is it., and it is meant to be worn with a full face mask. Without the spider strap of the FFM squeezing it in place, it will capture a lot of air.
CHANNCE D  The one I bought does not tuck into a wetsuit
Dave D  No, it doesn't feature a skirt and was intended solely for drysuit use. I actually bought a second one and had a skirt added, for wetsuit use as well . . .
CHAD T  I bought a few awhile back they had a very short collar on them. Might be enough to tuck inside the neck of your top but it's not much...maybe 1 1/2" or 2. Hope that helps.
mark r  No, it does not
BRIAN W  I dove this hood with my OTS guardian on new years day dive. I was not impressed with the performance of the hood. The mask fit normally for the first 40 ft and then began to loosen up. It got a bit worse as I descended. I called the dive at 70 feet. And we began to ascend. It did not fit any better for the rest of the dive at shallower depths. I tried yo tighten the mask but everything had shifted. I have an XL size. Should I go to the L size? I'm worried about the neck being to tight. Mydry suit has neoprene seals.
RYAN G  I would try the large depending if you have slight room in the xl. Don't risk it if you don it and it feels too tight. I've had issues with the hood here and there and I prefer to dive without it but in cold depths, you tend to just deal with the inconvenience.
ANTONY M  Do to pressure neoprene compresses pull the mask tighter at the beginning of the dive and adjust it on your way down to compensate for the compression
top
Share this item: