Top Rated Gear

Your Price:

$63.99

About Seasoft Pro/C6 6 mm Dry Suit Hood for Full Face Mask (FFM)

When Diving, the Deeper a diver goes the Colder it generally gets and with Increasing Pressure, a Typical Neoprene Hood gets thinner. If the Temperature is getting Colder and your Hood is getting thinner, you're going to get Cold. And, when you consider that 35% of Heat Loss is from the Head area, it seems like this would be a place to make sure you are Adequately-Protected to ensure Warmth and Comfort.

The SEASOFT Titanium PRO/C6 Hood has 4 different types of Nylon ll Neoprene including Compressed Neoprene for the Back-3 Panels of the Hood. This means that no matter how deep you go, they are still their Original-Thickness and working to keep you Warm! You will not find any Seams down the middle of the Chin either. This Seam, found in almost all Hoods today, can cause Jaw Fatigue. The Seam is there because it is less expensive to make a hood from just two halves. We do not believe that a hood is the place to go cheap.

The Hood has Titanium Flakes Poil Technology that creates 2-Layers of Titanium Foil that Reflects Cold away and Reflects your Heat in keeping you Warmer than Hoods without this Technology. The 6 mm material is going to Naturally-Fit and Stretch around your head better. This leaves less room for cold water to occupy UNDER your hood, this helps to maintain warmth as well. There are also two very Small-Holes for Air-to-Escape from the Inside-Crown of the Hood in case air enters your hood with a Thin-Baffle Built-Over the Holes to prevent Water from Entering.

The SEASOFT PRO / C6 6 mm Dry Suit Hood is a Commercial Dry Suit Hood designed to be worn with a Full Face Mask in Cold Water. The PRO/C6 has a Layer of Skin-In Neoprene on the Inside and on the Outside with a Layer of Tough Nylon in between these two layers. The Skin-In Neoprene allows the Hood to Seal to your Face and the Full Face Mask to Seal to the Hood. SeaSoft Pro/C6 Wetsuit Hood use 6 mm Neoprene with Glued and Sewn Seams for Strength and Durability. The Hood is available in sizes Medium, Large, X-Large and 2X-Large, is Black in Color and is covered by a 24 month limited warranty.

The Seasoft Pro/C6 6 mm Dry Suit Hood for Full Face Mask (FFM) is commonly used for Cold Water and more. The Seasoft Pro/C6 6 mm Dry Suit Hood for Full Face Mask (FFM) is popular because customers like the following qualities of the Seasoft Pro/C6 6 mm Dry Suit Hood for Full Face Mask (FFM): Good Fit, Warm.

Warranty Information

This product has a limited warranty of 24 months.

www.seasoftscuba.com
(800) 939-5510

Seasoft Pro/C6 6 mm Dry Suit Hood for Full Face Mask (FFM) Features

  • Specifically Designed for Full Face Mask Divers in Cold Water
  • 35% of Heat Loss is from the Head
  • Construction: 4 Different Types of Nylon ll Neoprene
  • Compressed Neoprene: Back 3-Panels of the Hood
  • Compressed Neoprene: Won't Get Thinner at Depth
  • Thicker Neoprene: Warmer Dive
  • No Chin Seam: Reduced Jaw Fatigue
  • Titanium Flakes Poil Technology: 2-Layers of Titanium Foil
  • Titanium Foil: Reflects Cold Away and Reflects your Heat In
  • 6 mm Naturally-Fit and Stretch Around Head Better
  • Small-Holes with Thin-Baffle on Inside-Crown Vent Trapped Air
  • Seams Glued and Sewn for Strength and Durability
  • Layer of Skin-In Neoprene on Inside and Outside with Layer of Tough Nylon in Between
  • Skin-In Neoprene allows Hood to Seal to Face and Full Face Mask to Seal to Hood
  • Sizes: Medium, Large, X-Large and 2X-Large
  • Color: Black
  • 2 Year Limited Warranty

Seasoft Pro/C6 6 mm Dry Suit Hood for Full Face Mask (FFM) Specifications

Material
Nylon Ll Neoprene
Thickness
6 Mm
Seams
Glued And Sewn
Available in the Following Sizes:
2X-Large, Large, Medium, X-Large
Weight [with packaging]
Large: 0.4 lb,
Medium: 0.6 lb,
2X-Large, X-Large: 0.65 lb
Mfr #
SKU
SSTC6H

Pro/C6 6 mm Dry Suit Hood for Full Face Mask (FFM) Customer Reviews

Write a Review

REVIEW SNAPSHOT®

by PowerReviews
Seasoft Pro/C6 6 mm Dry Suit Hood for Full Face Mask (FFM)
 
4.8

(based on 4 reviews)

Ratings Distribution

  • 5 Stars

     

    (3)

  • 4 Stars

     

    (1)

  • 3 Stars

     

    (0)

  • 2 Stars

     

    (0)

  • 1 Stars

     

    (0)

100%

of respondents would recommend this to a friend.

Pros

  • Good size/fit (4)
  • Warm (4)
  • Durable (3)
  • Prevents water movement (3)

Cons

    Best Uses

    • Cold water (4)
    • Professional (3)
    • Recreation (3)
      • Sizing:
      • Feels full size too small

         

        Feels half size too small

         

        Feels true to size

         

        100% 

        (4 reviews)

        Feels half size too big

         

        Feels full size too big

         
      • Diving Type:
      • Night diving (4), Open water diving (4), Outdoor professional (3)
      • Was this a gift?:
      • No (4)

    Reviewed by 4 customers

    Sort by

    Displaying reviews 1-4

    Back to top

     
    5.0

    Perfect for FFM

    By Btrax

    from Long Island, NY

    About Me Casual/ Recreational

    Verified Buyer

    Pros

    • Durable
    • Good Fit
    • Prevents Water Movement
    • Warm

    Cons

      Best Uses

      • Cold Water
      • Recreation

      Comments about Seasoft Pro/C6 6 mm Dry Suit Hood for Full Face Mask (FFM):

      I used this hood for my Padi FFM certification. After using several other hoods with the typical big head ballooning from excess air from the FFM. I found the seal on this hood to be excellent. It has a neoprene skin inside and out for a mask over the hood seal. Take the time to measure your head as it does require an almost perfect fit. I normally wear a large however i measured my head for this hood and ordered a medium. Initially it felt a little tight, but when in the water it worked out perfectly and it will stretch a bit. My friend ordered a large as he normally does and hat issues with the seal so measure and then order you won't be dissapointed I had no issues with a tight fit on the neck. .

      • Sizing:
      • Feels true to size
      • Diving Type:
      • Drift Diving, Night Diving, Open Water Diving, Rescue Diving, Wreck Diving
      • Was this a gift?:
      • No

      Comment on this review

       
      5.0

      cold weather ffm hood

      By Bluediver1

      from texas

      About Me Professional

      See all my reviews

      Verified Buyer

      Pros

      • Durable
      • Good Fit
      • Great For Full Face Masks
      • Prevents Water Movement
      • Warm

      Cons

      • Poor Craftsmanship

      Best Uses

      • Cold Water
      • Extreme Depths
      • Professional
      • Recreation

      Comments about Seasoft Pro/C6 6 mm Dry Suit Hood for Full Face Mask (FFM):

      This is my 2nd one the first one lasted a little over a year. The last one tore at the attached seal skin around the face. Don't pull it down around your neck with your head through the face opening take it off properly and it will last. These hoods are perfect for cold weather diving with a full face mask and it doesn't matter which mask. I have used it with aga,guardian, or ocean reef and it works perfectly. I highly recommend this hood

      • Sizing:
      • Feels true to size
      • Diving Type:
      • Drift Diving, Night Diving, Open Water Diving, Rescue Diving
      • Was this a gift?:
      • No

      Comment on this review

       
      4.0

      Bring on the full face masks!

      By DiveMedic766

      from Pound, VA

      About Me Advanced

      Pros

      • Durable
      • Good Fit
      • Warm

      Cons

        Best Uses

        • Cold Water
        • Professional

        Comments about Seasoft Pro/C6 6 mm Dry Suit Hood for Full Face Mask (FFM):

        Purchased hoods to be used on regional dive rescue operations in order to be able to utilize full face masks with diver-diver and diver-surface communications. True to fit. Comfortable, and will be put to good use. Bring on the full face masks!

        • Sizing:
        • Feels true to size
        • Diving Type:
        • Night Diving, Open Water Diving, Rescue Diving
        • Was this a gift?:
        • No

        Comment on this review

         
        5.0

        Good dry suit hood

        By lodiveco

        from New Hampshire

        About Me Professional

        Verified Buyer

        Pros

        • Good Fit
        • Prevents Water Movement
        • Warm

        Cons

          Best Uses

          • Cold Water
          • Professional
          • Recreation

          Comments about Seasoft Pro/C6 6 mm Dry Suit Hood for Full Face Mask (FFM):

          Very nice hood for use with a full face mask.

          • Sizing:
          • Feels true to size
          • Diving Type:
          • Night Diving, Open Water Diving, Wreck Diving
          • Was this a gift?:
          • No

          Comment on this review

          Displaying reviews 1-4

          Back to top

          Q&A

          Questions & Answers Powered by TurnTo®

          Questions about this item:

          BRIAN W  I dive a OTS Guardian FFM. My dry suit has neoprene seals. Im not sure about the right size to buy. Im not exactly fitting the classic neck and head measurements for one size. And with the neoprene seals that means the hood would need to come over the top of the neck seal. Can someone help with a sizing question?
          PATRICK G  Hello Brian, I am Patrick, I am a FF/EMT-eRDI Public Safety Diver. I purchased this hood and was very happy. Now I bought a size larger than Needed and found out I would have been fine with the standard size. I do have a bit of extra room and since my mask seals over the hood I'm fine. The neck should accommodate your dry seal . If you are like me you like to do it right the first time. I would suggest to go with your normal size and if too small return for refund. I hope this helps Patrick
          BRIAN W  I dive a OTS Guardian FFM. My dry suit has neoprene seals. Im not sure about the right size to buy. Im not exactly fitting the classic neck and head measurements for one size. And with the neoprene seals that means the hood would need to come over the top of the neck seal. Can someone help with a sizing question?
          PATRICK G  Hello Brian, I am Patrick, I am a FF/EMT-eRDI Public Safety Diver. I purchased this hood and was very happy. Now I bought a size larger than Needed and found out I would have been fine with the standard size. I do have a bit of extra room and since my mask seals over the hood I'm fine. The neck should accommodate your dry seal . If you are like me you like to do it right the first time. I would suggest to go with your normal size and if too small return for refund. I hope this helps Patrick
          BRIAN W  I dive a OTS Guardian FFM. My dry suit has neoprene seals. Im not sure about the right size to buy. Im not exactly fitting the classic neck and head measurements for one size. And with the neoprene seals that means the hood would need to come over the top of the neck seal. Can someone help with a sizing question?
          PATRICK G  Hello Brian, I am Patrick, I am a FF/EMT-eRDI Public Safety Diver. I purchased this hood and was very happy. Now I bought a size larger than Needed and found out I would have been fine with the standard size. I do have a bit of extra room and since my mask seals over the hood I'm fine. The neck should accommodate your dry seal . If you are like me you like to do it right the first time. I would suggest to go with your normal size and if too small return for refund. I hope this helps Patrick
          top
          Share this item: