OMS Profile Side-Mount System


About OMS Profile Side-Mount System

This system has filled a void and will offer the "at home" and traveling diver freedom from the weight concerns of handling "back mounted" doubles Side-mount allows individuals with limited physical abilities and lower back issues to enjoy the redundancy of two tank and two regulators by minimizing the amount of weight on the lower back and lowering the center of gravity for increased stability when entering/exiting the water Additionally reaching behind your head to shut off or turn on your manifold valve is a thing of the past as both cylinder valves are near your hands Traveling divers can relax knowing that easily available single tanks are all they need to enjoy redundancy and adequacy of gas supply for any dive around the world

Warranty Information

This product has a limited warranty of 12 months.
(845) 692-3600

OMS Profile Side-Mount System Features

  • Allows the diver to utilize most harness and wing systems (with standardized 11" O.C. hole spacing)
  • Over the shoulder design keeps the wing close to the divers back and allows air to travel freely from divers left to right.
  • Integral bib adds over 1/8" of abrasion protection to the vulnerable top part of the wing
  • No changes to the fit of the harness throughout the inflation of the wing from empty to full capacity
  • Permits the rebreather diver to back mount the CCR scrubber and side mount the Oxygen and Diluent cylinders
  • Enables the diver to back mount the bottom gas and side mount the decompression gases
  • Streamlines the diver allowing access to tight, remote, hard to reach caves and wreck passage ways

Questions & Answers Powered by TurnTo®

Questions about this item:

Shopper  Why Did You Choose This?
WILLIAM S  I wanted a piece of equipment that would allow me to use a stainless steel backplate for sidemount configuration diving. It is a modestly priced alternative to 'soft' BCDs configured for sidemount diving.
Beto F  Do I need a back plate to use this product or only the harness is ok?
JONATHON K  You will need a backplate. This screws into the backplate with low profile screws.
Shopper  Is it possible to attach it to the Hollis RIDE?
BRIAN C  Yes the SMS should attach directly to it with six bolts
Share this item: