Very nice accessory if you want to be able to remove your console without tools.
Works well
By
Joe
Tried to replace the Oceanic Pro Plus 2.1 computer high pressure hose with a braided hose. Unfortunately, the computer has a special hose. This unit allowed for simple removal of the computer.
LENORE N
I have an Oceanic Air Integrated computer with a quick release connection so that I can remove the computer easily. I'm looking to purchase a regular pressure gauge that I can connect instead of the Air Integrated computer. I'd like them to be interchangeable.
Will this product work for that purpose if attached to a regular pressure gauge?
JOE S
Hi Lenore,
you would have to buy a new hose with the fitting. The fitting is not sold separately. You could contact Oceanic Service to see if they would sell you one. 800 435-3483 ext 2.
Once you have a second fitting attached to the gauge, then yes, you could interchange between the two.
You may have to modify the boot that the gauge goes into so it will accept the male fitting on the gauge.
hope this helps.
VINCENT R
I use the same quick disconect fitting with a standard pressure guage. It works great. I use the quick disconect for my console , because I have a VEO 180 in my console w/ an Oceanic presure guage. Thi way I can disconect the console and have it remote to donwload my dive data
W. W
No, Oceanic uses a different type of disconnect. I have an Oceanic ProPlus and needed to change the hose. Tried the non-Oceanic and it did not work and the Oceanic is molded into their hose. So I ended up without a dis-connect.
Shopper
Will this work on a subgear xp-h?
JOE S
If it has the same threads as the pelagic gauges. I am not sure about sub-gear threads.
W. W
It should work on most gear that does not have non standard fittings.
MURRAY A
It should work as long as the threads match each other.
Shopper
Will this work with a suunto wireless transmitter? also, about the reviews from some people, they mentioned that you cannot submerse this product unless it is under pressure or with a device attached, it this correct?
MURRAY A
This should work with your transmitter as long as the threads match between the two.
The transmitter must be connected to the portion that threads to the first stage, otherwise there will be free flow of air from the quick connect if the transmitter is not connected. Hope this helps.
KEITH A
It should work with any gauge as it just screws in. I have never put mine in water unless my computer/gauge was attached. I have had it for four years with no trouble. It nice to be able to unhook computer for logging dives and travel. I have recommend this product to several of my friends and at least four have purchase it.
Shopper
Will this product work with Mares Puck Air Computer Console SKU: MRSPAC?
STAN K
Yes, It will work with any Hp hose connection to the first stage. Im using one for my hoseless uwatec computer and a second one for my backup computer /gauge console. They work great and can be taken apart and serviced.
COREY B
Universal - fits all consoles. I very much like mine & I've used my reg set up with the quick disconnect for over a hundred dives now, w/ no leakage or problems of any kind.