Will this work for the Ikelite Canon S95 camera case? (Ikelite Housing #6242.95)
Not sure if it will work for you but can give you the dimensions which may help you decide. It is somewhat adjustable. The center screw thead/size is standard so I don't believe that will be a problem. There are three separate positions (holes) the screw can go in with the widest dimension available being 4 and 3/4 inches (12 cm). My thought is that if you measure from the mounting hole (where the screw would go) to the outside edge of your camera housing and it is less than 4 and 3/4 inches it will work. Good luck. As far as quality is concerned, I am satisfied. I use it regularly with no problems. Check out my website (roatanwallpaper) for pictures I have taken with my camera equipped with this particular arm.
It is has the universal camera thread mount so it will absolutely work with the S95 case.
I believe the screw in the tray will fit most cameras and the only possible concern would be the dimensions of your camera case if it could be too wide to not touch the felx arm.
I had some trouble with keeping every thing tight when taking out of the water storage can on the dive boat. If you check it before entry into the water is will probably work. Also mine has corroded slightly at the screw that joins the flex arm to the tray base. The result is that I have not been able to change the arm to the other side. I have not tried a lubricant to see if it will free up, but it would be a good idea to treat it with WD 40 or a silicone spray after a dive to prevent corrosion.
Hope this helps!
sorry, I'm using it with a housing from Sony, made by Sea & Sea. Don't know if it will work with Ikelite.
Not sure about that case, but the bolt is the standard size of all tripod bolts. It fit my canon case perfectly and worked very well as good hand hold for underwater photos.
Hi Laura R, If your camera case has a female fitting on its' base. I'm sure it is universal to accept tripods and other accessories, including this flex arm.
I got mine for a gopro camera but i would think it would fit the ikelite housing if it has a tripod screw on the bottom. If not, then no it wouldn't work.
This is a universal mount. I've used mine on several differant camera cases. Never had any issues
J A S
Laura.. I can't see the bottom of the Ikelite housing, but if there is a tripod screw (can't image there wouldn't be one), then this arm should work. I have a Fuji FD31 in its housing and this has served me well.
I use it with a couple of different Canon cases, but not the Ikelite.
It should work ok. I had a little trouble with one case becuase the bottom bracket would not sit flush with the housing, but a few modification with a metal file did the trick.
Hope that helps.
I am not sure specifically it will or will not work with your camera. I will tell you it is a generic mounting system that works will all of our other cameras , diving or not. If your case has a threaded receiver on it, I would be willing to bet it will work great.
yes it will work with that housing set up. If you want mine I used it once in Belize. $25 shipped. 9104090132
It should work with any camera or housing that has a standard tripod mount on the bottom.