can it be fixed in Hollis sms100 (in the belt ) ?
and it will be fixed ir its going to move arround ?
MARTIN S this pocket fits any standard weight belt. As long as Hollis sms100 uses standard nylon webbing, then yes.
I have this pocket installed on an OMS comfort harness II and it works great...does not move or shift.
If you're worried about the pocket moving around, get a few weight stops and string one on each side of the pocket.
PATRICIA M Yes, it can be fixed on the harness belt. I have one integrated on one side and it is not removable. I only has about 3-4 inches of wiggle room and has caused no problems. The one I put on the other side is removable so when I do want it to stay put, I will rig it by putting a zip tie around the belt in front of it to stop it from moving or sometimes a cut tire tube slipped around the belt will keep it in place as well. Good Luck!
ROBERT G Looks like the Hollis SMS 100 harness uses standard 2 inch webbing, so these weight pockets should work just fine. I use them on my backplate rig. I keep them from moving around too much by pinning them close to the edges of the plate with belt slides, the kind with the teeth.
JOSEPH S I dont remember them sliding on my belt, but I would secure them anyway....
WILLIAM O It will move freely and easily on the SMS100 belt. I use 2 delrin 3 bar slides,one on each side to keep it where I want it.
BILLY N Fits 2" belt/webbing just fine. If there is room to slide, it will slide. Get some weight keepers to hold it in one place.