M K I have an older Mares console w/ PSI & compass but no depth ga. Will this fit a 2" diamater by 1' depth for my console?
Thanks,
Michelle
ELLIOTT M While my reg is Mares, my gauge console is Oceanic. However, I purchased this gauge and measured it in my console, and it looks like it should fit fine for you.
DENNIS M Yes...I verified that by looking at my console and it should work...I have a pressure and a depth guage in my console w\out a compass and I like it just great......One thing you can do is buy a quick connect for your pressure hose and a 2 hole boot. Then get a pressure guage .....Put the pressure and depth guage in one boot and keep your other boot as a back up. Then, if you ever have a guage malfunction on you, you have a spare to go to that only takes seconds to remedy....Dennis
IKE S Not a perfect fit...the pocket is a bit larger than the gauge...I created a fit by sticking several small pieces of foam weather stripping under the gauge...however even without a tight fit the gauge would not fall out....hope this helps.....Ike
NEAL L Michelle:
It is not clear where you plan to put the DG. The 2"x1" opening is fairly standard. It sounds like you do not have another opening on your console. If you do not, then you could get a hose adapter which will allow you to clamp the DG to the HP hose, just above the console, or you could get a 3-hole console.
I hope this helps; else refine your question and post back to the site
Neal