800.637.6880
212.645.1234
|
|
See More Similar
Spearguns »
|
|
Omer Tempest Pneumatic Gun with Regulator 50
|
List Price:
|
$247.00
|
|
Our Price:
|
$221.95
|
|
You Save:
|
$25.05 (10%)
|
SKU:
OSBWR
|
|
|
Warranty Information
This product has a limited warranty of 24 months.
www.omerdiving.com
(800) 853-1911
Whats in the box:Omer Tempest Pneumatic Gun with Regulator, Stainless Steel Shaft, Hand Loader, Hand Pump, Stainless Steel Spear Tip and Owner's Manual The TEMPEST 50/70/ models are equipped with a power regulator. This device facilitates easier loading: moving the lever to the FORWARD position allows the loading of the gun in short strokes. The power regulation is achieved by dividing the reservoir into two sections allowing the air to be released either totally or partially. When the gun is used at its lowest power the loading is easier as only a part of the air is expanded. Tempest is a highly versatile pneumatic gun that features excellent power and balance. It is extremely reliable and well suited for fishing in tight quarters and low visibility waters. The Tempest barrel has a special surface treatment that makes it impact and corrosion resistant. Omer performed simulated sea water submerging test of 10 years and the barrel showed no signs of aging or wear. A new ergonomically designed pistol grip in soft highly visible thermoplastic rubber for easy identification from the surface if gun must be left on the bottom between surface dives. Each gun is tested and comes pressurized at recommended setting from factory. Gun comes with a .30" (8 mm) Single Barb Spring Steel 7 mm Threaded Shaft with a Stainless Steel Double Barbed Tip. Also included with the Spear Gun is a Hand Loader, Hand Pump for charging the gun, a Shooting Line and Owner's Manual. Gun is available in 2 lengths of 19.69" and 27.56" (50 and 70 cm).
- Omer Tempest Pneumatic Gun with Regulator
- 2 Lengths of 19.69" and 27.56" (50 and 70 cm)
- Power Regulator Facilitates Easier Loading
- Highly Versatile Pneumatic Gun
- Excellent Power and Balance
- Extremely Reliable
- For Fishing in Tight Quarters and Low Visibility
- Impact and Corrosion Resistant Treated Barrel
- Ergonomically Designed Pistol Grip
- Grip: Soft Highly Visible Thermoplastic Rubber
- Pressurized at Recommended Setting from Factory
- 0.30 inch (8mm) Single Barb Spring Stainless Steel 7 mm Threaded Shaft
- Stainless Steel Spear Tip (DELTA) Double Flopper Barb
- Hand Loader
- Hand Pump
- Shooting Line
- Owner's Manual
| Total Length | 19.69" and 27.56" (50 and 70 cm) | | Shaft Diameter | 0.30 inch (8mm) | | Spearpoint | Yes, Double Barb | | Material | Pistol Grip: Thermoplastic Rubber
Spear and Tip: Stainless Steel | | Weight [with packaging] | 50: 2.7 lb, 70: 3.1 lb |
|
|
Related products for Omer Tempest Pneumatic Gun with Regulator 50
|
The TEMPEST 50/70/ models are equipped with a power regulator. This device facilitates easier loading: moving the lever to the FORWARD position allows the loading of the gun in short strokes. The power regulation is achieved by dividing the reservoir into two sections allowing the air to be released either totally or partially. When the gun is used at its lowest power the loading is easier as only a part of the air is expanded. Tempest is a highly versatile pneumatic gun that features excellent power and balance... more
Tags: OSBWR70, Omer, Spearguns, Add-On Gear, Omer Tempest Pneumatic Gun with Regulator 70
|
This highly technical Inflatable float, manufactured in 420D Nylon with two inside air chamber manufactured in very resistant PVC material, is part of the Inshore Hunting Line by Marco Bardi. Atoll is highly visible from great distances, with its 12x12 inch (30x30cm) flag positioned on top of a36 inch (95cm) long rigid flag pole and thanks to the bright red color of the top part. The bottom of the float is white to reduce its visibility to the fishes. On the top of the float there are three large pockets, ten plastic D rings and two Velcro straps... more
Tags: OSBT40, Omer, Spearguns, Add-On Gear, Omer Tempest Pneumatic Speargun 40cm
|
The Tempest Air Gun comes equipped with an 8mm (17-4PH) Spring Stainless Steel Shaft. When you are out on safari spear fishing, accidents can happen. Missing a fish and damaging your spear shaft can ruin a great trip that may have just got started. Having a spare shaft when out on a long trip can make the difference between a memorable trip and a busted safari! Always carry a spare shaft so you don't run the risk of getting skunked!The Tempest Series Spear gun has three different models. Each model uses a different length 8 mm shaft. The 40 cm (15.7") gun shaft is 35 cm (13.8"), the 50 cm (19... more
Tags: OSBT8S70, Omer, General Accessories, Assorted Accessories, Omer Tempest 8mm Stainless Steel Shaft 8 x 65cm for 70cm Gun
|
Divers need air; they get that air through their regulators. A regulator that isn't stored properly or protected during travel can prove to be more of a detriment than an asset once it reaches the water. Protect your regulator with the Traveler 50 regulator bag from Aqualung.... more
Tags: UDRT50, Aqualung, Gear Bags, Add-On Gear, AquaLung Traveler 50 Regulator 50 Bag
|
The Ellipse Titanium uses an elliptical housing for the second-stage regulator which is made from hi-tech polymers and titanium. The use of titanium and the polymer create a very lightweight regulator. All the internal components of the Ellipse are a dependable high performance downstream valve design. Once the valve has open the air is channeled by injection to the liquid silicone mouthpiece creating a venturi-effect enhancing the performance. On the top of the housing there is a flow deviator that acts on the Venturi effect, with dive/pre-dive switch... more
Tags: CSBRE9T, Cressi, Regulators, Essential Equipment, Cressi Ellipse Titanium MC9 Regulator
|
The Ellipse uses an elliptical housing for the second-stage regulator which is made from hi-tech polymers. All the internal components of the Ellipse are a dependable high performance downstream valve design. Once the valve has open the air is channeled by injection to the liquid silicone mouthpiece creating a venturi-effect enhancing the performance. On the top of the housing there is a flow deviator that acts on the Venturi effect, with dive/pre-dive switch... more
Tags: CSBREB5, Cressi, Regulators, Essential Equipment, Cressi Ellipse Black MC5 Regulator
|
The Ellipse uses an elliptical housing for the second-stage regulator which is made from hi-tech polymers. All the internal components of the Ellipse are a dependable high performance downstream valve design. Once the valve has open the air is channeled by injection to the liquid silicone mouthpiece creating a venturi-effect enhancing the performance. On the top of the housing there is a flow deviator that acts on the Venturi effect, with dive/pre-dive switch... more
Tags: CSBRES, Cressi, Regulators, Essential Equipment, Cressi Ellipse Steel MC5 Regulator
|
The MC9 Hyper-Balanced Diaphragm Actuated 1st stage regulator has a lightweight body covered by a protective techno-polymer elastomer shell. The regulator is equipped with four low pressure and two high pressure ports. Internally the 1st stage is coated with an anti-friction anti-corrosion material that reduces resistance and allows the critical components to move freely. This makes the components perform and last longer between annual servicing and increases performance... more
Tags: CSBX9PK, Cressi, Regulators, Essential Equipment, Cressi XS Compact MC9 Regulator Pink Plate
|
|
|